Rexroth A4VSO250 Hydraulic Piston Pump 250cc Flange Mount

A4VSO250DFR/22R-VPB25N00 A4VSO250DFR/22R-VZB13N00 A4VSO250DFR/22R-PZB13N00
A4VSO250DFR/22R-VPB13N00 A4VSO250DFR/22R-PPB13N00 German variable high-pressure industrial piston pump Rexroth A4VSO250

FAQ:

Maintenance & Troubleshooting

Q8: What does daily/regular maintenance involve?

• Keep the pump exterior clean from dust and oil污.

• Check oil levels before start-up and during operation.

• Listen for abnormal noises during operation, which may indicate internal issues like part wear or looseness.

• Regularly record operating parameters like pressure, flow, and temperature to monitor health.

• Change fluid filters periodically (e.g., every 1000 hours or as per conditions).

• Check and replace worn or aged seals.

• Follow lubrication requirements for various points.

• Inspect the coupling for looseness or wear.

Q9: The pump outputs insufficient flow or no flow at all. What could be wrong?

Primary reasons are:

• Insufficient Inflow: Caused by high suction line resistance, low oil level, excessive pump speed, or a clogged inlet strainer/suction line.

• Excessive Leakage: Worn internal parts (pistons, cylinder block, port plate) leading to high internal leakage.

• Swash Plate Angle: The swash plate angle might be set too small, minimizing displacement.

Q10: Why is there flow output when the control signal is at zero (neutral)?

This is often due to the control mechanism being off its neutral point. The cause can be a misadjusted, loose, or damaged controller. The solution is to re-zero, tighten, or replace the controller.

Q11: The output flow fluctuates. What is the cause?

Flow instability, often accompanied by pressure fluctuations, is frequently related to issues within the control piston mechanism. This can be due to contamination scratching the control piston, a weak or damaged control amplifier spring, or other damaged components. Addressing this usually requires disassembling the pump to inspect, repair, or replace the affected parts, and possibly increasing damping or spring stiffness.

Q12: The pump is leaking oil externally. Where should I look?

External leaks can originate from:

• Shaft Seal: Damaged or worn-out shaft seal.

• Pipe Connections: Loose hose connections, damaged fittings, or aged/ cracked sealing washers.

• Case Ports: Leaks from the variable mechanism cover bolts due to loose bolts or破损 seals.

• Case Imperfections: Rarely, sand holes in cast iron casings or poor welds.

• High Case Pressure: Excessive internal leakage can pressurize the case, damaging seals or pushing them out. Ensure the case drain line is unrestricted, of adequate size, and not too long.

Rexroth A4VSO250 hydraulic pump

250cc flange mount pump

hydraulic piston pump with warranty

Rexroth A4VSO250 Hydraulic Piston Pump 250cc Flange Mount Images